£5.50 ex VAT
Assetto Corsa Competizione wet setups developed for the Audi R8 GT3 EVO. Included in this package are two wet setups (medium and heavy wet) that can be used at all tracks. Also included is wet data from each track in the game.
*Wet setups are for GT3 cars only
**Physics updates are free, new content is charged for
Save time and remove the guessing. Use our setups out the box or as a baseline to improve upon. Coach Dave Academy setups are created by the best sim racers in the business and then back tested by real racing drivers. Our focus is not only on speed but also drivability and consistency.
All lap times listed below are set in Hot Lap mode with Medium Rain and Wet Track conditions. The laps are confirmed by two test drivers on the Coach Dave team. Please make sure your wet tires are always in the ideal operating window of 29.5 – 30.5 Psi .
Yes, ACC setups will be updated for free whenever the Kuno’s dev team make major changes to Assetto Corsa Competizione.
These updates will be free to download for Academy customers.
Our policy on setups is the following:
You will be notified of updates via email.
Tyre pressures change every session based on ambient and track temperature as well as track state (green, fast, optimum). We recommend that in a dry optimal qualifying and race session that you aim for a tyre pressure range of 27.5 – 28 psi. For wet tyres the pressure range slightly increases and your aim should be 29.5 – 30.5 psi.
Read more here about using the correct tire pressures in ACC.
Brake pad 1 and brake pad 4 compounds offer the same braking performance and efficiency when the brakes are optimal temperature. Brake pad 4 however has much worse pedal modulation, is exceptionally hard wearing and they have worse performance when the brakes are just outside their optimum working range. For almost any qualifying situation brake pad 1 is superior and more consistent.
Through personal experience here at Coach Dave Academy we recommend that any race spanning from 90 minutes through to 12 hours that you use brake pad compound 2. Please bear in mind that brake longevity is very dependent on car choice and driving style.
Each car has a different fuel burn rate per lap so this is very car specific. Excluding your outlap, you should aim to have enough fuel to complete 3 flying laps in a qualifying run. Depending on the circuit, expect to have to put 15-20L of fuel in the car before you leave the pits.
Read more about fuel management and calculations here.
The peak reference lap times for each circuit you see listed are completed on ACC in hotlap mode, with a track temperature of 30 degrees running the qualifying setups included in your bundle.
The data runs that are supplied are a separate entity to the hotlaps listed on the website using the qualifying setup. So with all of our setup bundles, the motec file included with every circuit contains 3 consistent laps with race fuel (60-65L) onboard using the race setup where available.
This gives you a much better idea as to where the correct braking, acceleration and turn in points are on the lap. We took this decision a long time ago as pure 1 hotlap data files provide much less feedback and references for customers looking to improve their technique.
This is because being able to replicate the same inputs lap after lap are much more important than a single hotlap that has many more variables that in some cases cannot be replicated again and again.